Impedance and Ohm's law in AC: V = ZI
In direct current, Ohm's law links voltage and current through a resistance. With a sinusoidal voltage, inductors and capacitors also oppose the current, and they shift it in time. Impedance captures both effects in one quantity, so the same law keeps working: .
This page defines the family of quantities that goes with it: resistance, reactance, impedance, inductance, capacitance, conductance, susceptance and admittance, with their symbols, their SI units and how they convert into one another.
The formula
Ohm's law in sinusoidal steady state: V and I are phasors (amplitude and phase), Z is the complex impedance in ohms.
| Symbol | Quantity | Unit |
|---|---|---|
| Voltage (phasor or rms value) | volt (V) | |
| Current (phasor or rms value) | ampere (A) | |
| Impedance | ohm (Ω) | |
| Resistance, real part of Z | ohm (Ω) | |
| Reactance, imaginary part of Z | ohm (Ω) | |
| Admittance, 1/Z | siemens (S) | |
| Conductance, real part of Y | siemens (S) | |
| Susceptance, imaginary part of Y | siemens (S) | |
| Inductance | henry (H) | |
| Capacitance | farad (F) |
From resistance to impedance
Ohm's law in its DC form applies to a resistor. When a linear circuit is driven by a sine wave at a fixed frequency, every voltage and current in it is a sine wave at that same frequency, described by an amplitude and a phase. Written as phasors, complex numbers that carry both, voltage and current are again proportional, and their ratio is the impedance:
The real part is the resistance, which turns energy into heat. The imaginary part is the reactance, which stores energy and gives it back each cycle without dissipating it. Engineers write the imaginary unit , with , because already stands for current.
With magnitudes only, the law reads : dividing the rms voltage by the magnitude of the impedance gives the rms current, and the angle of gives the time shift between the two. In DC the frequency is zero: an ideal inductor becomes a short circuit, an ideal capacitor an open circuit, and the law falls back to .
Resistance and conductance
Resistance , in ohms (Ω), measures how strongly a component opposes a steady current. For a uniform conductor it depends on the material and the geometry: the resistivity of the material, in ohm-metres (Ω·m), times the length , divided by the cross-section . Its reciprocal is the conductance , in siemens (S):
One ohm is the resistance that lets one ampere flow under one volt; one siemens is its inverse, one ampere per volt. Conductance is the natural quantity for parallel branches, because conductances in parallel add, just as resistances add in series. An ideal resistor has the same value at every frequency and no phase shift: its impedance is simply .
Inductance, capacitance and reactance
Inductance , in henries (H), relates the voltage across a coil to the rate of change of its current. Capacitance , in farads (F), relates the current into a capacitor to the rate of change of its voltage. These two relations hold at every instant, for any waveform:
Apply a sine wave of frequency , with the angular frequency in radians per second. Differentiating a sine wave multiplies its amplitude by and shifts it by a quarter period, so each component opposes the current with a reactance, in ohms, that depends on the frequency:
Inductive reactance grows with frequency and capacitive reactance shrinks with it. The minus sign records the opposite phase shifts: in an inductor the current lags the voltage by 90°, in a capacitor it leads by 90°. Many tables quote the capacitive reactance as the positive magnitude and keep track of the sign separately. As complex impedances:
Impedance: magnitude, phase, series and parallel
Impedance , in ohms, is the complex ratio of voltage to current. Its magnitude is the ratio of the amplitudes, and its angle is the phase by which the voltage leads the current:
A positive angle means an inductive circuit, where the current lags; a negative angle means a capacitive one, where it leads. The arctangent form holds when is positive, the usual case for a passive circuit. Impedances combine like resistances, provided the complex values are added and not their magnitudes:
Adding magnitudes is the most common error: a 30 Ω resistance in series with a 40 Ω inductive reactance makes a 50 Ω impedance, not 70 Ω, because the two voltages are a quarter period apart. A series inductor and capacitor can even cancel each other out, which is the resonance treated in the LC lesson.
Admittance, conductance and susceptance
Admittance , in siemens, is the reciprocal of impedance: it says how easily a circuit lets an alternating current through. Its real part is the conductance and its imaginary part the susceptance , both in siemens:
For a pure capacitor the susceptance is , and for a pure inductor . Admittances in parallel add, which makes them the convenient form for parallel circuits, just as impedances are for series ones.
When a circuit has both resistance and reactance, conductance is not the inverse of resistance, and susceptance is not the inverse of reactance. Taking the reciprocal of the complex impedance gives:
Only for a pure resistance, with , does the conductance reduce to . The signs follow from the same algebra: a capacitive circuit has a negative reactance and a positive susceptance.
Units and how they relate
All these quantities use SI derived units, defined in the SI Brochure of the International Bureau of Weights and Measures (BIPM). Resistance, reactance and impedance share the ohm; conductance, susceptance and admittance share the siemens. The henry and the farad can be written with the ohm and the second, which is why and come out in ohms:
Practical values span many orders of magnitude: inductances from nanohenries to henries, capacitances from picofarads to farads. Convert to henries, farads and hertz before applying the formulas. A prefix lost along the way, or the frequency used where the angular frequency is meant, is a frequent slip.
A resistor and an inductor in series at 1 kHz
A 30 Ω resistor in series with a 6.37 mH inductor is driven by a 10 V rms sine wave at 1 kHz. Find the impedance, the current and its phase, and the admittance of the circuit.
- Angular frequency and reactance: , .
- Impedance: , .
- Phase: : the circuit is inductive.
- Current: rms, lagging the voltage by 53.1°.
- Admittance: , , . The conductance is not .
Result: |Z| = 50 Ω at an angle of 53.1°, a current of 0.2 A rms lagging the voltage, and an admittance of 12 mS − j16 mS.
Common mistakes
- Adding the magnitudes of a resistance and a reactance in series. They act a quarter period apart: combine them as , or add the complex values.
- Using instead of in the reactance formulas. The result is then wrong by a factor of about 6.3.
- Taking the conductance as in a circuit that has reactance too. Use and .
- Quoting an impedance without its frequency. Reactance changes with frequency, so an impedance value means little without the frequency at which it was measured or calculated.
- Applying to a non-linear circuit, or to a non-sinusoidal waveform as a whole. Impedance is defined for sine waves in linear circuits; other periodic waveforms are handled one harmonic at a time.
Our design house in Montpellier, France designs and validates electronic boards, from schematic to production.
Frequently asked questions
- What is the difference between resistance and impedance?
- Resistance opposes current by dissipating energy and does not depend on frequency. Impedance is the complete opposition to an alternating current: a complex number whose real part is the resistance and whose imaginary part is the reactance of inductors and capacitors. Both are measured in ohms. In direct current, impedance reduces to resistance.
- What is susceptance in simple terms?
- Susceptance is the imaginary part of admittance, measured in siemens. Where reactance says how strongly an inductor or a capacitor opposes an alternating current, susceptance says how easily it lets it through. A capacitor has a susceptance of omega C, which grows with frequency; an inductor has minus one over omega L. In a circuit that also has resistance, susceptance is not simply the inverse of reactance.
- What are the units of inductance and capacitance?
- Inductance is measured in henries (H) and capacitance in farads (F), both SI derived units. One henry equals one ohm-second, or one volt-second per ampere; one farad equals one second per ohm, or one coulomb per volt. Practical values use prefixes, from nanohenries to henries and from picofarads to farads.
- Why do engineers write j instead of i?
- Because i is already the symbol for current. In electrical engineering the imaginary unit, the square root of minus one, is written j. An impedance written R plus jX therefore has the resistance as its real part and the reactance as its imaginary part, and multiplying by j corresponds to a phase shift of a quarter period.
- Is capacitive reactance negative?
- With the sign convention of complex impedance, yes: the impedance of a capacitor is minus j over omega C, so its reactance is negative, while an inductor's is positive. Many tables and calculators quote the capacitive reactance as a positive magnitude, one over two pi f C, and handle the sign separately. Both are correct as long as the convention is stated.
Sources
- OpenStax, University Physics Volume 2, 15.2 Simple AC Circuits
- OpenStax, University Physics Volume 2, 15.3 RLC Series Circuits with AC
- HyperPhysics (Georgia State University), AC Impedance
- All About Circuits, Lessons in Electric Circuits Vol. II, Review of R, X and Z
- Wikipedia, Susceptance (relation between conductance, susceptance, resistance and reactance)
- BIPM, The International System of Units (SI Brochure), derived units ohm, siemens, farad, henry
Formulas and values checked against these published references.